Home electricity load calculator
Find out how many kWh a home uses in a day, and when. Answer a few questions, check the appliances in each room, and you get a daily load profile you can use to size solar panels, an inverter and a battery.
1About the house
2Rooms and appliances
We’ve filled in typical appliances and values. Tap one to change how many there are, its watts and when it’s used. Remove what you don’t have and add what’s missing.
3Your results
Check it against your bill
Got a recent bill or prepaid history? Type the kWh of a normal month to see how close the estimate is.
Bills differ month to month, so compare with a normal month (not the December holidays).
How the estimate works
Each appliance uses its watts for the time it’s on: 2 TVs of 100 W for 4 hours come to 0.8 kWh a day. For appliances you use in short bursts, like the kettle, toaster or hair dryer, you say how many times a day you use them, and each use counts as a typical number of minutes. Washing machines, tumble dryers and dishwashers count in loads a week, at the kWh per load on their energy label. That energy is spread over the times of day you pick, so you see when the house uses electricity as well as how much. Fridges and freezers count at the kWh a day from their energy label, and the Wi-Fi router and alarm all day and night at their average draw.
The geyser (electric water heater) is usually the biggest single user, and it depends far more on how much hot water the household uses than on its 3 kW element. South African research puts hot-water use at about 50 litres a person a day in summer and 75 in winter, which takes about 3.2 kWh a person a day to heat on average. A 150-litre tank also loses about 2 kWh a day of heat. So the calculator works the geyser out from the number of people. A solar geyser or a heat pump uses roughly a third of that.
Appliances marked “Winter only”, like heaters and electric blankets, count in the three winter months. The geyser uses about a quarter more than average in winter and a quarter less in summer, because people use more hot water and the water coming in is colder. That’s why the results show a different total for each month.
Typical appliance wattages
These are the starting values the calculator uses. They come from the ratings and energy labels of appliances sold in South Africa, Eskom’s published assumptions and South African hot-water research. Where no product figure exists, the value is marked as an estimate. Your own appliances may differ: the rating is on a sticker on the back or bottom, and fridges, washing machines and dishwashers have an energy label with their kWh.
| Appliance | Typical power | Typical use | kWh | Based on |
|---|---|---|---|---|
| Kettle | 2 200 W | 5 minutes a boil | 0,18 a boil | Russell Hobbs and Kenwood 1.7 L kettles |
| Microwave (20 L, 700 W cooking power) | 1 050 W from the plug | 3 minutes a use | 0,05 a use | Defy, Midea and Toshiba 20 L models |
| Toaster (2 slice) | 900 W | 3 minutes a use | 0,05 a use | Russell Hobbs 815–950 W models |
| Air fryer | 1 700 W | 15 minutes a use | 0,43 a use | Defy and Russell Hobbs 1 600–1 750 W models |
| Stove plates | 2 000 W while cooking (estimate) | 40 minutes a meal | 1,3 a meal | Plates are 1 000–2 000 W each and switch on and off |
| Oven | 2 000 W average while baking (estimate) | 45 minutes a use | 1,5 a use | Ovens are rated 2–3 kW and switch on and off |
| Dishwasher | energy label | a load | 1,0 a load | Defy and Midea 13-place labels: 0.92–1.05 |
| Washing machine | energy label | a load | 0,6 a load | Defy 7 kg front loader label: 0.59–0.97 |
| Tumble dryer | energy label | a load | 3,15 a load | Defy: a typical cycle about 3.15 |
| Hair dryer | 2 200 W | 10 minutes a use | 0,37 a use | Remington 2 200 W dryers |
| Iron (average while ironing) | 1 200 W (estimate) | 30 minutes a use | 0,6 a use | Steam irons are 2 000–2 400 W and switch on and off |
| Fridge-freezer | energy label | all day | 1,0 a day | Defy labels 0.6–0.9 a day; Defy says 1.0–1.7 in real use |
| Chest freezer | energy label | all day | 0,8 a day | Defy chest freezer labels 0.64–0.82 a day |
| TV (55 inch LED) | 100 W | 4 hours | 0,4 | Samsung 55 inch energy labels: 80–110 W |
| TV decoder | 30 W | 4 hours | 0,12 | Its power supply is rated 40 W at most |
| Laptop | 65 W | 3 hours | 0,2 | Common 65 W chargers |
| Wi-Fi router | 12 W | all day | 0,29 | Estimate |
| LED light | 9 W | 4 hours | 0,04 | The LED replacement for a 60 W bulb |
| Heater | 2 000 W | 2 hours (winter) | 4,0 | Oil and fan heaters on the top setting |
| Electric blanket (double) | 100 W | 2 hours (winter) | 0,2 | Pure Pleasure doubles: two 50 W sides |
| Air conditioner (12 000 BTU inverter) | 1 100 W cooling | 3 hours | 3,3 | LG and Midea 12 000 BTU: about 1 090 W |
| Pool pump | 750 W | 6 hours | 4,5 | 0.75 kW is the common size; about 8 hours in summer, 4 in winter |
| Gate motor (average) | 15 W (estimate) | all day | 0,36 | Its battery charger draws up to 28 W while charging |
| Geyser, per person | 3 kW element | all day | 3,2 a day, plus 2 for the tank | South African hot-water research; measured tank losses |
Backup and load-shedding
Tick “Keep on during load-shedding” for the appliances that should run from a battery when the grid is off. The results then show how many kWh a day they use, which is what the battery has to hold, and how many kW they’d draw if they were all on at once, which is what the inverter has to deliver. Most homes leave the geyser, stove and oven off backup.
How accurate is it?
It’s an estimate from typical values, so treat it as a starting point. Real appliances differ, and so do habits. A recent electricity bill or prepaid history gives the true monthly kWh: type it into “Check it against your bill” and you can scale the results to match. Smart-meter data is better still, because it also shows exactly when the electricity was used. See using smart-meter data to build a load profile.
Using the results for a solar design
“Use in the designer” passes the monthly kWh and the daily load profile to the Finance page in the Lekker Sun designer, where they feed the savings and battery simulation. The Finance page is part of Pro, Business and bought projects. You can also print the results, or download them as a CSV file in the same layout as the designer’s typical-day template. For sizing a battery from the profile, see how to size a home battery from the load profile.
Questions people ask
How many kWh does a house use per day?
It depends mostly on how the water is heated and how many people live there. With this calculator's typical values and an electric geyser and stove, a 1-bedroom home with one person comes to about 12 kWh a day (370 kWh a month), a 2-bedroom home with two people about 16 kWh, a 3-bedroom home with four people about 23 kWh (710 kWh a month) and a 4-bedroom home with five people about 28 kWh. Winter days use about a quarter more than the average, summer days less. With a solar geyser the same 3-bedroom home drops to about 14 kWh a day, and with gas water heating and gas cooking to about 6.5 kWh.
How do I work out how many kWh an appliance uses?
Multiply its watts by the hours it is on and divide by 1,000. A 2,000 W heater used for 2 hours uses 2,000 × 2 ÷ 1,000 = 4 kWh. The watts are usually on a sticker on the back or bottom of the appliance. Appliances that switch themselves on and off, such as fridges, freezers and ovens, use less than their sticker rating over a day, so use an average figure for them.
How much electricity does a geyser use?
An electric geyser is usually the biggest single user in a home. South African research puts hot-water use at about 50 litres a person a day in summer and 75 in winter, which takes about 3.2 kWh a person a day to heat. A 150-litre tank also loses about 2 kWh a day of heat. So a family of four uses about 15 kWh a day for hot water: more in winter, less in summer. A solar geyser or a heat pump uses roughly a third of that.
What size inverter do I need for load-shedding?
The inverter must deliver everything you want on backup that could run at the same time. Tick “Keep on during load-shedding” for those appliances and the calculator adds up their watts. Allow headroom on top, because fridges, pumps and other motors draw several times their running power for a moment when they start. Most homes leave the geyser, stove, oven and heaters off backup. Have an installer confirm the size.
How big a battery do I need?
The battery has to hold the backup appliances' kWh for as long as the power is off, and more if it must carry the house overnight without solar. Then allow for the depth of discharge and the round-trip efficiency. The calculator gives the backup load in kWh a day and the load profile shows when it's used; the guide on sizing a home battery from the load profile goes through the sums.
Is my information saved or sent anywhere?
No. The calculator runs in your browser and keeps your list in that browser only, so it is still there when you come back on the same device. Nothing you type is sent to Lekker Sun. “Use in the designer” passes the results to the designer in the same browser.
This calculator is general information to help you plan and compare options. It is not engineering, electrical or financial advice. Have a qualified installer check the design.